WOODWORKING MACHINERY
MACHINERY DIRECTORY
Explore edge banding equipment for panel furniture and finished board edges.
A straight-through automatic edge bander and a swing-arm machine address different panel paths. The MFB104 record includes minimum panel length and width as well as panel thickness. The Ruiao record describes straight and curved edges, but does not publish a numerical feed speed. List your smallest panel, largest component, edging material and required finishing stages. Ask which trimming and finishing operations are included in the offered configuration. The PE-2C7J sheet adds a 60 mm minimum panel width and a 0.4–3 mm tape range, yet names no processing units, so its finish cannot be compared with MFB104 until the unit list arrives. Ask for the permitted panel thickness as well as the tape range, and calculate output from your own parts rather than from feed speed.
Use the same component or incoming material to ask each supplier a comparable question. The entries below identify a selection issue for each published record. They are not test scores or a ranking of manufacturers.
| Published equipment | Selection issue | Ask in the quotation |
|---|---|---|
| Pinmai PE-2C7J straight-edge banding machine Jinan Pinmai CNC Equipment | 0.4–3 mm × 12–55 mm tape, 10–50 mm panels at least 60 mm wide, 13–18 m/min, 12 kW, 0.7 MPa air. | Confirm the processing units fitted, glue system, air consumption and edged samples of your thinnest and narrowest parts. |
| Swing-arm edge bander for straight and curved panels Dezhou Ruiao Woodworking Machinery | Tape height does not establish panel limits or curve radius | What are the panel limits and minimum curve for the proposed support arrangement? |
| MFB104 automatic edge bander Weihai Deli Woodworking Machinery | Panel size and tape size are different checks | Which electrical-power figure belongs to the offered configuration? |
A missing answer stays unconfirmed. Working area, wheel diameter, tape height, motor ratings and process counts must retain their original labels; they are not interchangeable capacities. Keep accessories, handling, utilities and the sample acceptance job explicit when comparing offers.
Numeric ranges match where capacities overlap. Selected values must all match; series combinations require manufacturer confirmation.
0 products excluded because selected specifications are not published.
Edge banders
The Pinmai PE-2C7J is a straight-edge banding machine for edge tape 0.4–3 mm thick and 12–55 mm wide, on panels 10–50 mm thick and at least 60 mm wide, at 13–18 m/min. It draws 12 kW, needs at least 0.7 MPa compressed air and five 100 mm extraction connections, and weighs 1250 k…
Edge banders
This Dezhou Ruiao swing-arm edge bander glues edge tape onto straight and curved panel edges. It takes tape 10 to 60 mm high and heats glue in an enlarged, insulated glue pot with five heating rods and automatic temperature control. Feed speed is adjustable, glue is applied to b…
Edge banders
The Weihai Deli MFB104 is an automatic edge banding machine for panels 10 to 60 mm thick, at least 60 mm wide and 160 mm long. It applies edge tape 10 to 65 mm wide at a feed speed of 18 m/min and runs on 0.7 MPa compressed air. The machine weighs 1300 kg net and measures 3860 ×…