SMV8D precision sliding table saw

The SMV8D sizes full sheets of melamine-faced board, MDF and plywood in a cabinet or furniture workshop. The scoring blade cuts a shallow groove in the underside face just ahead of the main blade, so laminated and veneered boards come off without chipped edges. Electric lifting lets the operator set blade height from the control panel when changing between thin panels and thicker stock.

It is a manually fed saw: the operator pushes the board on the sliding table past a fixed blade. That makes it a flexible machine for mixed work and short runs. For long runs of identical full sheets, a beam saw from the same maker is the usual next step.

The two capacity figures answer different questions. The 3200 mm table length sets the longest crosscut or straight-line cut you can make in one pass. The 1250 mm cutting width sets how wide a strip you can rip between blade and fence. A 2440 × 1220 mm sheet fits both, while a 3050 mm sheet uses most of the table.

The 80 mm height applies with the blade vertical. When the blade tilts for a bevel, the usable height falls, so if you cut mitres on thick stock, ask for the height at your angle.

The 5.5 kW main motor drives every cut. The 0.75 kW scoring motor is a separate drive for the small scoring blade only. Three spindle speeds let the operator match blade speed to blade diameter and material; the operating manual should state which speed suits which blade.

Among the panel saws on this site, the Zhongding ZD400T is the closest comparison: also a sliding table saw, with a 400 mm main blade, 120 mm cutting height at 90° and 80 mm at 45°. Read our sliding table saw capacity guide before comparing it with other saws, because table length, rip width and cutting height have to be read together. The edge bander that follows the saw in a typical shop is a separate purchase; the Weihai Deli MFB104 is one example of an edge-banding machine listed here.

Ask for a cutting demonstration with one full-size board and one small repeat part in your own material. Record the finished length and width, chipping on both faces, the blade and scoring setup and whether loading is included in the time.

• Largest board size and material
• Thickness and any bevel angle
• Required edge quality on both faces
• Power supply and extraction capacity
• Accessories you expect in the price

• Table version and outrigger included
• Cutting height at the bevel angle you need
• Blade diameter and the speed recommended for it
• Electrical supply and starter type
• Which Yongqiang group company supplies and services the saw